CA-1.003: Cable Anchor, knob only
Overview
Replacement Knob End for CA-1 (silver).
Our CA-1 Cable Anchor (not included) secures multiple cables in place to prevent accidental release. Use side knob to tighten CA-1 to the side of your L-Plate. Then open the pinch bar by unscrewing the top knob. Slide your cables into the groove and tighten the pinch bar until snug. Don't over-tighten as cables can sustain damage if clamped too tight.
Note that knobs are not captive, so if you over-loosen the knobs you may lose them. (Each CA-1 comes with two CA-1.003 knobs)
Our CA-1 Cable Anchor (not included) secures multiple cables in place to prevent accidental release. Use side knob to tighten CA-1 to the side of your L-Plate. Then open the pinch bar by unscrewing the top knob. Slide your cables into the groove and tighten the pinch bar until snug. Don't over-tighten as cables can sustain damage if clamped too tight.
Note that knobs are not captive, so if you over-loosen the knobs you may lose them. (Each CA-1 comes with two CA-1.003 knobs)
Ratings & Reviews
No reviews available
Be the first to Write a Review